Frequently asked questions about the phasing out of R-22 refrigerant, as mandated by the Clean Air Act and regulated by the U.S. Environmental Protection Agency (EPA).
What is R-22?
R-22 (also known as HCFC-22) is a refrigerant commonly used in air conditioning equipment and other applications. It is a type of manmade chemical known as hydrochlorofluorocarbons (HCFCs).
Why is it being phased out?
The release of HCFCs and other manmade chemicals into the atmosphere have depleted the Earth’s protective ozone layer and created an “ozone hole” over the South Pole. Restricting and eventually banning the production and use of HCFCs and other ozone-depleting chemicals will allow the ozone layer to eventually return to its normal level. Scientists estimate that with a worldwide phaseout of ozone-depleting substances, the ozone layer will recover by about 2075.
The phaseout of R-22 is part of a worldwide initiative, the Montreal Protocol on Substances that Deplete the Ozone Layer, to end the use of all ozone-depleting chemicals.
Why is the ozone layer important?
The Earth’s ozone layer protects the planet from the sun’s harmful ultraviolet radiation. Depletion of this shield means more radiation reaches the Earth’s surface where it can harm people and ecosystems.
What will replace R-22?
The most common non-ozone-depleting refrigerant in use today is R-410A, known by trade names PURON, SUVA 410A and GENTRONAZ-20.
When does the phaseout of R-22 begin?
In the United States, the phaseout begins on January 1, 2010, when the U.S. bans production and import of R-22 for new equipment only. This means that all new air conditioning equipment produced in or imported to the U.S. must use R-410Aor another alternative refrigerant. R-22 can still be produced or imported for servicing of existing equipment.
How is the phaseout structured?
There are four major steps to the phaseout of R-22:
- 2010 – Ban on production, import and use of R-22 and HCFC-142b, except for continuing servicing needs of existing equipment.
- 2015 – Ban on production, import and use all HCFCs, except for continuing servicing needs of refrigeration equipment.
- 2020 – Ban on remaining production and import of R-22 and HCFC-142b. After 2020, the servicing of systems with R-22 will rely on recycled or stockpiled quantities.
- 2030 – Ban on remaining production and import of all HCFCs.
Why is the phaseout over such a long period?
The phaseout has been designed to allow adequate time to switch to ozone-friendly refrigerants as part of normal equipment replacement, so consumers and businesses can avoid having to replace equipment that still has useful life.
R-22 is used in numerous commercial and industrial applications, but for homeowners the most direct impact of this phaseout is in home air conditioners and heat pumps.
Can I still use my R-22 equipment?
Yes. There is no ban on the use of R-22 equipment made before January 1, 2010. You are not required to replace existing equipment.
Can I still repair existing R-22 equipment?
Air conditioners, heat pumps and other systems that use R-22 may still be serviced, maintained and repaired, and R-22 will still be available for use in equipment made before 2010.
Can R-22 be mixed with R-410A in a system?
No. R-410Acan only be used in a system designed for the higher pressures and unique characteristics of this refrigerant.
Can R-22 equipment be modified to use R-410A?
It is possible to switch to R-410A or another alternative refrigerant in an existing R-22 system, but this requires significant modifications of the equipment.
Can I still purchase an R-22 system?
There is no ban against purchasing systems using R-22, but after December 31, 2009 manufacturers are no longer permitted to produce or import R-22 systems.
How do costs compare between R-22 and R-410A equipment?
Currently, a new R-410Asystem is slightly more expensive than a comparable R-22 system. Other factors should be considered, including the long-term cost and availability of R-22 refrigerant and parts, energy efficiency, performance and reliability.
How does the energy efficiency compare between R-22 and R-410A equipment?
There are both R-410Aand R-22 systems that qualify for the ENERGYSTAR
H rating, which means the system is at least 14% more efficient than a standard new system. However, R-410Asystems offer the additional advantage of using a non-ozone-depleting refrigerant. How will the phaseout affect R-22 equipment repairin the future? As the phaseout continues, R-22 refrigerant will become more scarce and parts will be less common. This means service and maintenance of these systems is likely to be increasingly more expensive and less convenient in years to come.
How can I minimize the impact on the ozone layer with my existing R-22 system?
The most important thing you can do is maintain your equipment. Major leaks rarely develop in properly installed and maintained equipment. However, it is necessary to service your system properly to minimize environmental damage and maintenance costs. Be sure to select a reliable service contractor who is EPA-certified to service equipment containing R-22.
How will the phaseout affect R-22 equipment replacement in the future?
Since R-22 equipment cannot be manufactured or imported after January 1, 2010, the availability of new R-22 systems will decrease each subsequent year. Of course, R-410Asystems will be available as replacements.
Are R-410Asystems available now?
Yes. Systems that use R-410Aor other non-ozone-depleting alternative refrigerants are available now and will become increasingly common.
Are service contractors trained to work on R-410A systems?
Yes. Service contractors repairing and installing R-22 systems today should be technically capable of R-410Arepair and installation as well. As the new systems become more common, more contractors will be familiar with them. However, it is a good idea to make sure that the dealer or contractor you use is trained in the installation and service procedures required for R-410Aequipment.
When will R-22 no longer be available for purchase?
R-22 will continue to be manufactured and imported until 2020 for service of existing equipment. After 2020, only recycled or reclaimed R-22 will be available. It is difficult to predict when supplies will run out, but the EPA anticipates that supplies should be available until most R-22 equipment is retired.
Will R-22 equipment parts continue to be available?
No manufacturers have announced plans to stop producing R-22 repair parts. However, availability of parts in the future will be determined by normal market conditions.Can R-410Abe used in an R-22 system? R-410Acannot be used in an unmodified R-22 system, because it requires equipment designed for the higher pressures and unique characteristics of R-410A. Although it is possible to update an R-22 system for R-410Arefrigerant, the modifications are significant and often cost-prohibitive.
Can recovered R-22 be used again?
Yes. Under special circumstances, EPA regulations allow equipment to be recharged with recovered refrigerant – meaning refrigerant removed from the appliance and stored in an external container without testing or processing.
If the refrigerant is to be used in equipment with different ownership, it must be reclaimed or recycled. Reclaiming means reprocessing the refrigerant to meet industry standards with specialized machinery not generally available at a job site or repair shop. Recycling means extracting it and cleaning it for reuse without meeting the requirements for reclamation.
What is the proper way to dispose of R-22?
Recovered HCFC refrigerants including R-22 should be sent to an EPA-certified refrigerant reclaimer. Only EPA-certified reclaimers may reclaim and sell used refrigerants to a new owner. Contractors may also send HCFC refrigerants to be destroyed. They must be completely destroyed at a destruction efficiency of 98% or greater, using one of the approved destruction technologies. In the United States, incineration technologies are most commonly used for this purpose.
If I am an AHS Home Warranty customer, what will the R-22 Phase Out mean to me?
Since the R-22 refrigerant will be phased out gradually, AHS will continue to repair and replace with R-22 systems until the parts and systems are no longer available, within the EPA’s mandated guidelines. When the supply inventory of R-22 related parts and systems have depleted and it is necessary to replace with R-410Arefrigerant systems, American Home Shield will cover the cost to replace the air conditioner and its modifications necessary by the transition from R-22 to R-410A refrigerants. (Refer to the air conditioning section of the warranty contract for coverage details.)
This information is courtesy of American Home Shield Warranty.
Coldwell Banker United, Realtors has partnered with American Home Shield to provide a Home Warranty to both our Selling and Buying Clients. I always offer my clients the protection of an American Home Shield Home Warranty. Both Buyers and Sellers should insist on an American Home Shield Warranty because they are the founding and leading Home Warranty Company with over 35 years experience caring for customers. With over 1.3 Million Home Warranties Nationwide, and over 11,000 Contractors within their service network, they lead the industry in delivering innovative home warranty products to customers. When I list your house for sell, I pay for the home warranty for you from the time you list with me through your closing date. This protects your home while it is on the market which can protect you from investing more money into your home while you’re trying to sell. It lowers your cost for repairs that may need to be completed before closing and helps avoid delays on closing due to unexpected breakdown of systems. Having a warranty also attracts buyer and adds value to your home. It demonstrates an intent to sell your home in good working order and gives the buyer an avenue of restitution, other than you, should any covered systems break down after purchase. When I list your home, I will go over the contract and explain the warranty options available and help you decide which warranty best suits your needs. Your American Home Shield Warranty provides your buyer confidence before and after their home purchase. Should your home require service, repairs, or replacement of covered systems while it is under contract for sell, you the seller will only pay your service charge for each trade service call. (An example of a trade service call would be an electrician, another service trade might be a plummer.) Most buyers insist on a home inspection before purchase and want repairs made when necessary. In that instance, you would only pay the one time service fee. I promote the American Home Shield Warranty because it is a product that can save Sellers money and puts your home on a pedestal by making it appealing to perspective buyers in todays heavily inventoried market. This warranty will also make your home more competitive with newly constructed homes. With American Home Shield Warranties, you have the flexibility to create the plan that fits your individual lifestyle and budget. This way you don’t pay for coverage you won’t use.
